|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The service was quick and simple, finding the service manual easy and it appears to be the original with colour schematics. It contained the info I was after and so sorted the problem.
I have copied it to CD and attached the envelope to the inside back cover of the owners manual. Good manual and excelent service. Robin Wood, Wood Electronics, New Zealand.
;
Exactly what was needed to assess the product - excellent value and great service
 ;
Nice to have the service manual for the Sony DCR-TRV345E now. The document is of excellent quality.
;
MACKIE HR824 26 pages English-only Service Manual contains:
1) HR824 technical overview with the description of front and rear panel switches.
2) HR824 specs
3) Block Diagram
4) Wiring Diagram
5) Packaging management
6) Spare part & final assembly list (for PCB rev A and B) + exploded view
7) Test Procedures (where, how to measure voltage...) including Test Point diagram on the PCB.
8) IC and Transistor charts.
Excellent guide: very clear, good scan quality enabling us to print readable diagram :-)
Note:
Mackie HR824 make extensive use of surface mount devices (SMD). Service on the HR824 must
only be undertaken by experienced service technicians with the right tools, experience and patience to perform surface mount rework when needed.
;
This Service manual is very well scanned and its clean to read, no any anti-theft words that un-english could understand. I got my CCD600 working with this manual and it´s clear shematics :)
Installation 1. Install the Y axis belt (item 3) onto the carriage assembly making sure the belt is in between the two slider rods (see figure 14, item 5). 2. Install the carriage assembly ' page 8 42 Note: Make sure the Y axis belt is not twisted. 3. Install the Y axis belt (item 3) around the Y axis belt pulley (item 6). 4. Install the Y axis belt pulley with the belt into the Y axis tensioner holder (item 2). 5. Install the belt around the Y axis motor pulley (item 5).
The spring is under high tension and could spring out of the Y axis tensioner holder.
Caution: Cup your hand over the Y axis tensioner holder in the next step to avoid losing the spring. 6. If you have removed the tensioner wedge clip (item 4) and the spring (item 1), install it now. To tension the belt, use a small flat blade screw driver to release the wedge tensioner clip from its position in the Y axis tensioner holder. 7. Install the following: 1. Left Hand Cover ' page 8 18. 2. Right Hand Cover ' page 8 21. 3. Window and Top Cover ' page 8 15. 8. Install the power cable.
WARNING
8-40
HP DesignJet CP Series Printers
Removal and Installation
|
|
|
> |
|
